The xception.io module automates how boards are set before the multi-saw. It uses industrial vision to capture the board’s true geometry, calculates the best placement for your target widths, and positions the board automatically - without stopping the line or replacing your saw.
What the system does
- Identifies each board on the infeed and measures its shape (bow, twist, taper, wane).
- Computes the optimal offset and angle for the widths you specify.
- Positions the board in real time before the multi-saw, synchronized with your conveyor speed.
- Outputs traceability data so you can track yield improvements over time.
Operating modes
- Advisory mode: Displays the recommended position for the operator or PLC while leaving saw set points unchanged.
- Integrated mode: Positions the board and, where supported, adjusts multi-saw settings automatically to lock in the optimal cut plan.
Integration approach
- Retrofit onto existing conveyors and controls - no need to replace the saw.
- Works with irregular, unedged feedstock common in high-variation lines.
- Designed for 24/7 industrial environments with sawdust, vibration, and changing moisture.
Results you can expect
- Higher yield per log through precise alignment.
- Less waste and rework caused by operator variability.
- Stable quality across shifts and species changes.
- Faster payback because the module preserves your installed base.
Implementation steps
- Line assessment and throughput targets.
- Mechanical and controls fit, including safety review.
- Installation and commissioning during planned downtime.
- Training and support to keep recovery gains consistent.
If you want to increase recovery from your multi-saw without rebuilding the line, schedule a review at xception.io/contact.